F 250 2WD Super Duty V8-6.0L DSL Turbo VIN P (2004)
12. Install the seat side trim panel screws, the seat adjuster control knob and cover.
1
Install the three seat side trim panel attachment screws (two shown).
2
Install the seat recliner lever cover and screw.
3
Install the lumbar control knob.
Vehicles with power seats
13. Connect the seat control switch electrical connector.
All seats
14. Restore the vehicle to operating condition.
1
WARNING: To reduce the risk of serious personal injury, read and follow all warnings, cautions, notes, and instructions in the
supplemental restraint system deactivation/reactivation procedure.
Install the seat on the side with the affected safety belt retractor.
2
WARNING: To reduce the risk of serious personal injury, read and follow all warnings, notes, and instructions in the seat removal
and installation procedure.
Reactivate the supplemental restraint system (SRS).
3
WARNING: The restraint system diagnostic tool is for restraint system service only. Remove from the vehicle prior to road use.
Failure to remove could result in injury and possible violation of vehicle safety standards.
With all the restraint system diagnostic tools removed, prove out the supplemental restraint system (SRS). See: Air Bag(s) Arming and
Disarming/Service and Repair/Prove Out Procedure
4
Check the active restraint system for correct operation.
15. Check the active restraints for correct operation.
SuperCab
RETRACTOR - REAR SAFETY BELT AND TONGUE, SUPERCAB
