F 250 2WD Super Duty V8-6.0L DSL Turbo VIN P (2004)
Transmission Mount: Service and Repair
4R100 Automatic Transmission
Transmission Insulator and Retainer
Removal
NOTE: 4x2 shown, 4x4 similar.
1. With the vehicle in NEUTRAL position it on a hoist. For additional information, refer Maintenance/Service and Repair.
2. Remove the nuts.
3. Install a suitable high-lift transmission Jack.
4. CAUTION: Be sure not to raise the back of the transmission too high. If it makes contact with the underbody, damage to the TSS and OSS
sensors will occur.
Remove the rear transmission mount.
1
Raise the transmission up off the rear crossmember support.
2
Remove the bolts.
3
Remove the rear transmission mount.
Installation
1. CAUTION: Be sure not to raise the back of the transmission too high. If it makes contact with the underbody, damage to the TSS and OSS
sensors will occur.
Install the rear transmission mount.
1
Raise the transmission up.
