F 250 2WD Super Duty V8-6.4L DSL Turbo (2009)
Removal
1. Remove the fuel rail.
2. NOTE: Mark the location of the rocker arm assemblies prior to removing.
Remove the bolts and the rocker arm assemblies as needed.
3. NOTE: Mark the location of the valve bridges before removing.
Remove the valve bridges.
-
Inspect the valve bridges for wear or damage and replace as needed.
4. NOTICE: To prevent engine damage, keep the push rods in the order in which they were removed. Install all push rods back in their
original positions.
Mark the location and remove the push rods.
5. Clean and inspect the rocker arm assemblies. For additional information, refer to Rocker Arm Cleaning and Inspection See: Service and
Repair/Procedures/Rocker Arm Cleaning and Inspection.
6. Clean and inspect the push rods. For additional information, refer to Push Rod Cleaning and Inspection See: Service and Repair/Procedures/Push
Rod Cleaning and Inspection.
Installation
1. NOTICE: To prevent engine damage, keep the push rods in the order in which they were removed. Install all push rods back in their
original positions.
NOTE: Install the copper ends of the push rods up.