F 250 2WD Super Duty V8-6.4L DSL Turbo (2009)
Arm/Disarm Switch: Service and Repair
Door Disarm Switch
Removal and Installation
1. Remove the LH front door trim panel.
2. Position the watershield aside.
3. NOTE: It is not necessary to remove the door lock cylinder from the exterior door handle cover. It is shown removed only for clarity.
Remove the E-clip and disconnect the latch lever from the door lock cylinder.
4. NOTE: The door disarm switch can be installed in more than one position. Before removing the switch from the door lock cylinder, mark the
position of the switch in relation to the door lock cylinder.
Remove the door disarm switch.
-
Disconnect the electrical connector.
5. NOTE: The door disarm switch can be installed in more than one position. Use the reference marks applied in Step 4 to index the new door
disarm switch to the door lock cylinder.
To install, reverse the removal procedure.
