F 250 2WD Super Duty V8-7.3L DSL Turbo VIN F (1999)
CAUTION:
On the inboard side of the left frame rail, the pickup box cable must be located between the brake line and the frame rail. On the outboard side, the
cable must be located between the parking brake cable and the frame rail. See Figure 9.
b.
Starting from the inboard side of the left frame rail, install the new bolt through the cable eyelet so that the flat side is against the frame rail,
and then through the parking brake cable bracket hole in the frame rail. Place the parking brake cable bracket, then the other cable eyelet,
over the bolt and install the retaining nut. Tighten the nut to 48 Nm (35 lb-ft).
c.
Working through the right rear wheel opening, position the pickup box cable through the hole in the pickup box channel brace as shown in
Figure 10.