F 250 2WD Super Duty V8-7.3L DSL Turbo VIN F (1999)
Oil Cooler: Service and Repair
Removal and Installation
Removal
1. Drain the radiator.
2. Raise and support the vehicle.
3. Remove the oil filter.
4. Disconnect the block heater.
1. Disconnect the retainer.
2. Disconnect the cable.
5. Remove the two bolts from the oil cooler front header.
6. Remove the three bolts from the oil cooler rear header.
7. Remove the oil cooler.
8. Remove the oil cooler front and rear header gaskets from the engine.
9. Clean the gasket mating surface on the engine and the oil cooler.
Installation
1. Position the oil cooler in the vehicle.
