F 250 2WD Super Duty V8-7.3L DSL Turbo VIN F (1999)
WARNING: Always wear safety glasses when repairing an air bag supplemental restraint system (SRS) vehicle and when handling an air bag module.
WARNING: Carry a live air bag module with the air bag and trim cover or deployment door pointed away from your body. This will reduce the risk
of injury in the event of an accidental deployment.
WARNING: Remote deployment is to be performed outdoors with all personnel at least 6.1 meters (20 feet) away to ensure personal safety. Due to
the loud report which occurs when the air bag is deployed, hearing protection is required.
WARNING: Do not place the driver or passenger air bag module with the trim cover or deployment door facing down, as the forces of the deploying
air bag can cause it to ricochet and cause personal injury.
NOTE: The passenger air bag module is shown. The driver air bag module is similar.
1. Remove the passenger air bag module. Refer to ModulePassenger Air Bag in this section.
2. Cut the two connector wires on the passenger air bag module and strip 25 mm (1 inch) of insulation from the ends of the wires.
3. Obtain two wires at least 6.1 meters (20 feet) long and connect one end of each wire to each of the wires on the passenger air bag module.
4. Place the passenger air bag module on a flat surface with the deployment door facing upward in an open outdoor area.
5. Remain at least 6.1 meters (20 feet) away from the passenger air bag module.
6. Deploy the air bag by touching the other ends of the two wires to the terminals of a 12-volt battery.
