F 250 2WD Super Duty V8-7.3L DSL Turbo VIN F (1999)
2. Install the rear brake anti-lock sensor.
1
NOTE: Do not apply force to the plastic rear brake anti-lock sensor connector.
Position the rear brake anti-lock sensor and install the rear brake anti-lock sensor bolt.
2
Connect the electrical connector.
3. NOTE: When the battery is disconnected and reconnected, some abnormal drive symptoms may occur while the vehicle relearns its adaptive
strategy. The vehicle may need to be driven 16 km (10 mi) or more to relearn the strategy.
Connect the battery ground cable.
Front
Removal
1. Disconnect the battery ground cable.
2. Disconnect the front anti-lock brake sensor electrical connector.
1
Disconnect the electrical connector.
2
Detach the front anti-lock brake sensor wire harness from the brake hose.
3. Remove the front anti-lock brake sensor.
1
Remove the bolts.
2
Remove the front anti-lock brake sensor.
Installation