F 250 2WD Super Duty V8-7.3L DSL Turbo VIN F (1999)
Hydraulic Hose: Service and Repair
Removal
1. Raise and support the vehicle.
2. Disconnect the line from the clip at the floor flange and the dash panel.
3. Remove the hydraulic line from the clutch slave cylinder.
^
Remove and discard the roll pin.
^
Remove the hydraulic line.
4. Lower the vehicle.
5. Remove and discard the roll pin holding the hydraulic line to the clutch master cylinder.
6. NOTE: Check that the O-ring is still in the outlet port of the clutch master cylinder. If not, replace it.
Disconnect the line from the clutch master cylinder by applying a slight tug on the line.
Installation
1. NOTE: Check that the O-ring is in place on the line. Check the clutch slave cylinder port to be sure there is not an O-ring in the port.
Insert the new line into the clutch master cylinder outlet port.
^
Check that the connection is secure by applying a slight tug to the line.
2. Install the clutch master cylinder tube.
^
Position the line and install the roll pin.
^
Tug on the clutch master cylinder tube.
3. Raise and support the vehicle.
4. Connect the line to the clip on the floor flange and dash panel.
5. Lower the vehicle.
6. Bleed the system See: Clutch Fluid/Service and Repair.
