F 250 4WD HD Pickup V8-460 7.5L VIN G EFI (1997)
13. Insert Temperature Control Cable Removal Tool T94P-18532-A on A/C temperature cable to release two of three locking tabs. Use a small
flat-bladed screwdriver to release the third locking tab and remove A/C temperature cable from A/C temperature control bracket by pulling
directly from A/C temperature control bracket.
14. Remove A/C temperature control bracket from vehicle, paying particular attention to routing of cable to aid in installation.
INSTALLATION
1. Route A/C temperature cable in the same manner as cable removed.
NOTE: All temperature control components are shipped from the factory in a full warm position and must remain in this position until fully
installed. In addition, all existing components must be set in a full warm position before any installation can be attempted.
2. Install A/C temperature cable on heater air plenum chamber by aligning locating tab on the A/C temperature cable with locating position on heater
air plenum chamber. Make sure the temperature blend door actuator post is aligned within the cable head cam.
3. Push A/C temperature cable over temperature control door cam until an audible click is heard indicating engagement. If a click is not heard, it will
be necessary to visually ensure cable is fully seated in position.
4. Position temperature control in full warm position. Install A/C temperature cable on A/C temperature control bracket and push until an audible
click is heard.
5. Install A/C temperature control bracket on A/C control and rotate into position.
6. Install screw retaining A/C temperature control bracket to A/C control.
7. Connect electrical hardshell connectors to heater blower motor switch and function control switch.
8. Install A/C control into instrument panel opening.
9. Install four screws retaining A/C control to instrument panel.
