F 250 4WD HD Pickup V8-460 7.5L VIN G EFI (1997)
10. Remove the direct clutch piston.
11. Using the (A) O-Ring Tool, remove the direct clutch piston (B) inner and (C) outer seals.
ASSEMBLY
NOTE: Soak the clutch plates for 15 minutes in clean Motorcraft MERCON or MERCON V Automatic Transmission Fluid or equivalent meeting
FORD specification.
1. Install the direct clutch piston inner seal.
NOTE: The seal lip must face downward.
2. Install the direct clutch piston outer seal.
NOTE: The seal lip must face downward.