F 250 4WD HD Pickup V8-460 7.5L VIN G EFI (1997)
4. Remove and discard orifice cup plug and spring and stop assembly.
-
Clean and inspect bore, making sure bore is clean of any debris.
CAUTION:
-
Do not reuse orifice cup plug or spring and stop assembly. Make sure the old rubber stop is removed (it can become separated from the
spring assembly).
-
Use care not to damage any machined surfaces of stator support.
5. Obtain Banding Tool D89L-7700-A or equivalent and one 10 mm bolt prior to removing pump body bolts. This tool is needed to align the pump
with the control body assembly during reassembly.