F 250 4WD HD Pickup V8-460 7.5L VIN G EFI (1997)
5. Lower the control body and stator assembly onto the pump body, aligning the 28mm round hole in the control body with the 28mm hole in the
pump body.
CAUTION:
-
Prior to pump assembly, make sure all cup plugs are installed.
-
Inspect mating surfaces of pump body and control body to make sure they are clean and free of nicks and burrs.
6. Loosely install eleven M8x50 bolts. Install one 10mm alignment bolt in the position shown and install Banding Tool D89L-77000-A or equivalent
with clamp by filter inlet. Align outer bolt holes and tighten banding tool.
7. Tighten bolts to 24-31 Nm (18-23 Ft lbs.). Remove banding tool and 10mm alignment bolt. Make sure the outer edges of the control body and the
pump body are completely aligned.
