F 250 4WD HD Pickup V8-460 7.5L VIN G EFI (1997)
Seals and Gaskets: Service and Repair
Input Shaft Seal
NOTE: The through-bore of oil seal is designed such that the oil seal can be removed without having to disassemble the transmission if removal and
replacement of oil seal is all that is required.
REMOVAL
1. Remove the three release bearing guide tube retaining screws. Remove guide tube.
2. Tap on the oil seal with a screwdriver until the oil seal turns. Then use a screwdriver to pry out the seal.
INSTALLATION
1. Insert new oil seal over input shaft and drive it flush with the case using Input Shaft Seal Replacer T95T-7025-A.
2. Insert guide tube over input shaft. Insert and tighten three bolts to 24 Nm (18 Ft lbs.).
