F 250 4WD LD Pickup V8-281 4.6L VIN W EFI (1997)
Pressure Regulating Solenoid: Service and Repair
REMOVAL
1. Remove the manual control lever shaft.
2. Disconnect the Electronic Pressure Control (EPC) solenoid electrical connector.
CAUTION: Do not pull on the wires. This can damage the wires or the connector and can result in transmission solenoid or sensor failure.
3. Remove the EPC solenoid.
INSTALLATION
1. Install the EPC solenoid.
2. Connect the Electronic Pressure Control (EPC) solenoid electrical connector.
