F 250 4WD LD Pickup V8-5.4L SOHC VIN L (1997)
Keyless Entry Transmitter: Description and Operation
NOTE: The remote entry features will not function when the ignition switch is in the RUN or ACC position.
The keyless entry remote transmitters:
^
Are reprogrammable.
^
Must be set at the same time.
To unlock the driver door and disarm the anti-theft system:
^
Press the UNLOCK button on the keyless entry remote transmitter.
NOTE: If more than five seconds have elapsed since the first press of the UNLOCK button, pressing the UNLOCK button again will only unlock the
driver door a second time.
To unlock all doors:
^
Press the UNLOCK button on the key less entry remote transmitter a second time, within five seconds of the first unlock.
To lock all doors and arm the anti-theft system:
^
Press the LOCK button on the keyless entry remote transmitter once.
To confirm that the doors have been locked and that the anti-theft system has armed:
^
Press the LOCK button again, within five seconds of the first press. The horn will chirp once if the doors have locked and all doors are closed.
The horn will chirp twice if a door is open, indicating that the anti-theft system will not arm until all the doors are closed.
To activate the panic alarm:
^
Press the red PANIC button on the keyless entry remote transmitter. The horn will sound, the headlamps and exterior lamps will flash for a
maximum of two minutes and 45 seconds.
To deactivate the panic alarm:
^
Press the red PANIC button again on the key less entry remote transmitter.
^
Turn the ignition switch to RUN/ACC.
Programming
NOTE: All keyless entry remote transmitters must be programmed at the same time.
To program (or reprogram) the keyless entry remote transmitters into the RAP module, perform the following steps:
1. Make sure that the anti-theft system is not armed or triggered.
2. Turn the ignition switch from OFF to RUN five times within ten seconds, ending in RUN. If the RAP module has successfully entered program
mode, it will lock and then unlock all doors.
3. Press any button on a keyless entry remote transmitter, and the doors will lock and then unlock to confirm that each keyless entry remote
transmitter has been programmed.
4. If the door locks do not respond for any keyless entry remote transmitter, wait several seconds and press the button again.
5. Turn the ignition switch to the OFF position, or wait up to five minutes after step 2, to exit program mode. If a keyless entry remote
transmitter has been programmed (or reprogrammed), the RAP module will lock and unlock all doors one last time to confirm.
Inputs and Outputs
The RAP module receives input from the following components for electronic door lock system operation:
^
Keyless entry remote transmitters.
^
Door ajar output from the Generic Electronic Module (GEM).
^
Door unlock switches (LH and RH).
^
Brake on/off switch.
^
Transmission Range (TR) sensor.
^
Remote entry antenna.
