F 250 4WD LD Pickup V8-5.4L SOHC VIN L (1997)
Brake Drum
-
Install the brake drum.
1
Position brake drum.
2
Install the rubber wheel centering ring.
-
If adjusting the rear brakes with the brake drums installed, refer to the procedure in this section.
WARNING:ALWAYS REMOVE ANY CORROSION, DIRT OR FOREIGN MATERIAL PRESENT ON THE MOUNTING
SURFACES OF THE WHEEL OR THE SURFACE OF THE WHEEL HUB, BRAKE DRUM OR FRONT DISC BRAKE
ROTOR THAT CONTACTS THE WHEEL. INSTALLING WHEELS WITH OUT PROPER METAL TO METAL
CONTACT AT THE WHEEL MOUNTING SURFACES CAN CAUSE THE LUG NUTS TO LOOSEN AND COULD
ALLOW THE WHEEL TO COME OFF WHILE THE VEHICLE IS IN MOTION, CAUSING LOSS OF CONTROL.
-
Clean the wheel hub mounting surface.
Wheel And Tire Assembly
-
Install tire and wheel assembly.
NOTE: If equipped with air suspension, reactivate the system by turning on the air suspension switch.
-
Lower the vehicle.
-
Remove the pin in the parking brake control and verify proper parking brake operation.
-
Check brake operation before driving
