F 250 4WD LD Pickup V8-5.4L SOHC VIN L (1997)
Rear Disc Brake Caliper
-
Remove the rear disc brake caliper.
CAUTION:Do not remove the guide pins or guide pin boots unless a problem is suspected. The guide pins are meant to be sealed for life and are not
repairable.At the time of publication there are no approved materials or procedures for re-lubing the caliper slide pins. Other greases may
swell the guide pin boots resulting in contamination and accelerated corrosion or wear of the caliper slide pin mechanism.
1
Remove the bolts.
2
Lift the rear disc brake caliper off the rear wheel disc brake adapter.
INSTALLATION:
Rear Disc Brake Caliper
-
Install the rear disc brake caliper.
CAUTION:To prevent interference with rear disc brake caliper operation, install only the correct caliper bolt.
NOTE: Make sure the stainless steel shoe slippers are properly positioned. Replace if worn or damaged.
NOTE: When installed, the locator notch on the Brake Pads will be located at the upper end of the rear disc brake caliper.
1
Position the rear disc brake caliper.
2
Install the bolts.
-
Install the brake hose. Use new copper washers; connect;the brake hose.
-
Bleed the brake system; refer the Hydraulic System service and repair section.
-
Clean the wheel hub mounting surface.