F 250 4WD LD Pickup V8-5.4L SOHC VIN L (1997)
2. Properly orientate the air bag sliding contact.
1
The air bag electrical pigtail must point to the three o'clock position.
2
The dot on the steering shaft must be at the nine o'clock position.
3. Press at the six, twelve and three o'clock positions to seat the air bag sliding contact.
4. Rotate the wiring and secure into two wire clips.
5. Connect the two electrical connectors. Snap into the bracket.
6. Install the key-in-ignition warning indicator switch.
7. If a new clockspring is used, remove the yellow anti-rotation tab.
8. Install the upper steering column shroud.
9. Install the ignition switch lock cylinder.
1
Turn the ignition switch lock cylinder to the RUN position.
2
Insert the ignition switch lock cylinder into the steering column housing.
3
Make sure the ignition switch lock cylinder is fully seated and aligned in the inter-locking washer before turning the key to the OFF position.
This will permit the retaining pin of the ignition switch lock cylinder to extend into the hole in the steering column.
10. Rotate the ignition switch lock cylinder, using the key, to make sure of correct mechanical operation in all positions.
11. Install the lower steering column shroud.
12. Install the steering column opening cover.
