F 250 4WD LD Pickup V8-5.4L SOHC VIN L (1997)
5. Connect the axle end of the anti-wind bar.
NOTE: When installing the anti-wind bars be sure to align with the top spring plate holes.
6. Connect the height sensor.
7. Remove (A) Hi Lift Jack.
8. Clean the wheel hub mounting surface.
WARNING: WHEN A WHEEL IS INSTALLED, ALWAYS REMOVE ANY MATERIAL PRESENT ON THE MOUNTING
SURFACES ON THE SURFACE OF THE WHEEL OR THE SURFACE OF THE WHEEL HUB, BRAKE DRUM OR BRAKE
ROTOR THAT CONTACTS THE WHEEL. INSTALLING WHEELS WITHOUT PROPER METAL TO METAL CONTACT AT THE
WHEEL MOUNTING SURFACES CAN CAUSE THE LUG NUTS TO LOOSEN AND THE WHEEL TO COME OFF WHILE THE
VEHICLE IS IN MOTION, CAUSING LOSS OF CONTROL.
9. Install the wheel and tire assembly.
