F 250 4WD LD Pickup V8-5.4L SOHC VIN L (1997)
5. Remove the snap ring.
6. Disconnect the front axle actuator motor assembly.
(1) Fully extend the front axle actuator motor shaft.
(2) Plug the vacuum ports.
(3) Pull the front axle actuator motor assembly out.
(4) Push the front axle actuator motor assembly away, disconnecting the lever from the slot in the actuator motor shaft.
7. Remove the front axle actuator motor assembly and boot.
(1) Remove the boot.
(2) Remove the front axle actuator motor assembly.
8. Remove the front axle housing tube assembly, please refer to Transmission and Drivetrain/Drive Axles, Bearings and Joints/Service and
Repair/Procedures/Front/ See: Axle Tube Disassembly and Assembly
