F 250 4WD Pickup L6-300 4.9L (1982)
Choke Housing: Technical Service Bulletins
Electric Choke System - Testing Tool
Article No: 82-10-13
May 24, 1982
Subject:
Rotunda Choke Cap Tester No. 90-0001
FORD
All Vehicles With Single - And Two-stage Electric Chokes
LINCOLN-MERCURY
All Vehicles With Single - And Two-stage Electric Chokes
The tool was recently released to improve performance and reduce diagnosis time when servicing choke systems.
Testing time has been reduced to a few minutes with the all electric two-stage choke system. The temperature range of the tester is from -1 °F to 165 °F.
For optimum tool performance, shop air with a line pressure of 90 PSI with 6-8 C.F.M. volume is required.
An adaptor is provided to service older model single-stage and hot-air-only systems. The unit is also recommended for testing other heat
sensitive/actuated components and auto/temp control systems.
Refer to the Engine/Emission/Diagnosis Manual and the Manufacturers Instruction Manual (provided) for procedures and instructions.
Warranty Status: Information Only
