F 250 4WD Pickup V6-4.2L VIN 2 (1998)
2
Remove the bolt.
3
Remove the rear brake anti-lock sensor.
CAUTION: Clean off dirt and debris that may have collected around the rear brake anti-lock sensor before removal to prevent fluid
contamination.
INSTALLATION
1. Clean and inspect the rear brake anti-lock sensor.
1
Clean the axle mounting surface.
2
Inspect and clean the magnetized rear brake anti-lock sensor pole piece.
3
Inspect the rear anti-lock brake control o-ring for damage. Replace if necessary.
4
Lightly lubricate the rear anti-lock brake control o-ring with Motorcraft Synthetic Rear Axle Lubricant F1TZ-19580-B or equivalent meeting
Ford specification WSL-M2C192-A.
CAUTION: Use care not to get dirt in the rear axle housing.
2. Install the rear brake anti-lock sensor.
1
Position the rear brake anti-lock sensor and install the rear brake anti-lock sensor bolt.
NOTE: Do not apply force to the plastic rear brake anti-lock sensor connector.
2
Connect the electrical connector.
