F 250 4WD Pickup V6-4.2L VIN 2 (1998)
1
Remove the parking brake lever bolt lock nut, at the back of the brake backing plate, and the parking brake lever bolt.
2
Remove the parking brake rear cable and conduit from the parking brake lever.
5. Remove the parking brake lever.
6. Remove the adjusting screw assembly.
1
Disconnect the brake shoe adjusting lever cable from the brake shoe adjusting lever.
2
Remove the brake shoe adjusting lever cable.
3
Remove the cable guide.
4
Remove the adjusting lever return spring and the brake shoe adjusting lever.
5
Remove the brake shoe adjusting screw spring.
6
Remove the brake adjuster screw assembly.
7. Remove the rear brake shoe and lining.
1
Remove the brake shoe anchor pin guide plate.
2
Remove the brake shoe hold-down springs and the brake shoe hold-down spring pins.
3
Remove the rear brake shoes and linings.
INSTALLATION
1. Lubricate the brake backing plate friction points. Use Silicone Brake Caliper Grease and Dielectric Compound D7AZ-19A331-A (Motorcraft
WA-10) or an equivalent silicone compound meeting Ford specification ESE-M1C171-A.
