F 250 4WD Pickup V6-4.2L VIN 2 (1998)
^
Use adhesive type shrink tubing only.
^
Use Rosin core Mildly Activated (RMA) solder, not acid core solder.
4. Bend the wires back in a straight line.
NOTE: Wait for the solder to cool before moving the wires.
5. Position the (A) heat shrink tube over the (B) wire repair.
^
Overlap the heat shrink tube on both wires.
6. Use Master Heat Gun to heat the repaired area until hot wax flows out both ends of the heat shrink tube.
7. Connect the battery ground cable.
NOTE: When the battery is disconnected and reconnected, some abnormal drive symptoms may occur while the vehicle relearns its adaptive
strategy. The vehicle may need to be driven 16 km (10 mi) or more to relearn the strategy.
