F 250 4WD Pickup V6-4.2L VIN 2 (1998)
Camshaft Position Sensor: Service and Repair
Camshaft Position (CMP) Sensor
REMOVAL
1. Partially drain the cooling system.
2. Remove the air cleaner.
3. Disconnect the heater water outlet tube.
1. Disconnect the fuel charging wiring harness from the heater water outlet tube.
2. Remove the heater water outlet tube bolt.
3. Position the heater water outlet tube aside.
4. Disconnect the CMP sensor electrical connector.
CAUTION: Do not turn the crankshaft or camshaft during the removal and installation procedure or the fuel system control will be out of time with
the engine and possibly cause engine damage.
5. Remove the Camshaft Position sensor (CMP sensor).
1. Remove the bolts.
2. Remove the camshaft position sensor from the camshaft synchronizer.
