F 250 4WD Pickup V6-4.2L VIN 2 (1998)
4. Preload the torsion bar.
(1) Tighten the torsion bar tool until the new adjustment bolt and nut can be installed.
(2) Turn the adjustment bolt until preliminary adjustment marks are aligned.
CAUTION: The torsion bar adjustment bolt is coated with dry Loctite and must be replaced if it is backed off or removed. Failure to do so can
cause the adjustment bolt to loosen up during operation and a loss of vehicle alignment.
5. Install the torsion bar cover plate.
(1) Position the torsion bar cover plate.
(2) Install the retaining bolts.
6. Install the wheel hub.
7. If equipped with 4WABS, install the anti-lock sensor wire bracket bolt.
(1) Position the anti-lock sensor wire.
(2) Install the bolt.
8. Adjust the ride height.
