F 250 4WD Pickup V6-4.2L VIN 2 (1998)
12. Remove the two outboard boot clamps.
a. Remove the outboard clamp protectors.
b. Grip the boot clamps and peel the clamps away from the boot.
13. Remove the outboard front wheel driveshaft joint boot.
14. Inspect for contaminated grease.
NOTE: If grease is contaminated, clean and inspect the joint for wear. Replace the outboard CV joint and interconnecting shaft assembly if worn
or damaged.
ASSEMBLY
1. Pack the outboard Constant Velocity (CV) joint with grease.
a. Use High Temp Constant Velocity Joint Grease E43Z-19590-A or equivalent meeting Ford specification ESP-M1C207-A provided in the boot
kit.
b. Spread any remaining grease from service kit evenly inside the outboard boot.
2. Position the outboard front wheel driveshaft joint boot and outboard boot clamps.
