F 250 4WD Pickup V6-4.2L VIN 2 (1998)
INSTALLING WHEELS WITHOUT PROPER METAL-TO-METAL CONTACT AT THE WHEEL MOUNTING SURFACES CAN CAUSE
THE LUG NUT TO LOOSEN AND THE WHEEL TO COME OFF WHILE THE VEHICLE IS IN MOTION, CAUSING LOSS OF
CONTROL.
8. Install the tire and wheel assembly.
1
Position the tire and wheel assembly.
2
Install the lug nuts and lower the vehicle.
3
Tighten the lug nuts.
4
Install the center cap.
Drum Brake
REMOVAL
1. Raise and support the vehicle.
2. Remove the wheel and tire assembly.
3. Remove the axle housing cover.
^
Drain the lubricant.
4. Remove the rear brake drums.
5. Remove the differential pinion shaft.
1
Remove the differential pinion shaft lock bolt.
2
Remove the differential pinion shaft.
6. Remove the u-washers.
1
Push the axle shafts inboard.
2
Remove the u-washers.
CAUTION: Do not damage the rubber O-rings in the U-washer grooves.
