F 250 4WD Pickup V6-4.2L VIN 2 (1998)
Flywheel: Service and Repair
Flywheel Housing to Block Dowels
REMOVAL
1. Remove the flywheel housing to block dowel using a drift pin where the flywheel housing to block dowel is installed in an open hole and locking
pliers where the flywheel housing to block dowel is installed in a blind hole.
NOTE: Take care not to damage the flywheel housing to block dowel holes or surface areas around the flywheel housing to block dowel hole
during removal.
INSTALLATION
1. Install all flywheel housing to block dowels by driving them into place using a brass or plastic mallet.
NOTE: Care should be taken to drive the flywheel housing to block dowel squarely into place until fully seated without damaging the
surrounding surface areas.
