F 250 4WD Pickup V8-302 5.0L (1986)
Figure 12 - DANA MODEL 44IFS FRONT DRIVING AXLE
4.
Remove the six Allen-head capscrews retaining the manual locking hub cap to the hub body and remove the cap.
5.
Remove the snap ring that retains the axle shaft in the hub body assembly.
6.
Remove the lock ring seated in the groove of the wheel hub.
7.
Remove the body assembly from the hub. If the body is difficult to remove, install two capscrews and pull the body assembly out of the hub.
8.
Remove the outer locknut from the spindle with a Spanner Locknut Wrench, T83T-1197-B.
9.
Remove the lockwasher from the spindle.
10.
Remove the inner locknut from the spindle using a Spanner Locknut Wrench, T83T-1197-B.
11.
Remove the hub and rotor assembly and outer bearing from the spindle.
12.
Remove the nuts retaining the spindle to the knuckle. Lightly tap the spindle with a rawhide hammer to remove it from the knuckle, 13. Remove
the splash shield from the steering knuckle.
