F 250 4WD Pickup V8-302 5.0L VIN F 2-bbl (1985)
C1AZ-19590-B (ESA-M1C75-B) or equivalent.
16. Place the inner bearing cone and roller assembly in the wheel hub, (Fig. 5). Install a new hub inner seal with tool T75T-1115-B.
17. Position the wheel assembly at the axle housing. Wrap the threads of the spindle with electricians tape. Carefully slide the wheel assembly
straight (to avoid seal damage) onto the axle housing spindle. Remove the electricians tape.
18. Install the outer wheel bearing and start the bearing adjuster nut. Remove the wheel jack.
19. While rotating the wheel, tighten the adjusting nut to 163-189 Nm (120-140 ft. lb.) using special tool Hex Locknut Wrench T7OT-4252-D or
Octal Locknut Wrench T7OT-4252-E. Back off the adjusting nut enough to get a 0.025-0.254 mm (0.001-0.010 inch) end play. This should
require 1/8 to 3/8 turn. Position the locking wedge in the key way slot and pound wedge into position (Fig. 6).
The locking wedge and the adjusting nut can be used over again, provided the locking wedge cuts a new groove in the nylon retainer material
within the 1/8 to 3/8 turn specified. The wedge must not be pressed into a previously cut groove.
NOTE: If it is not possible to back the nut off within the limits of 1/8-3/8, turn to obtain proper assembly (0.025-0.254 mm or 0.001-0.010 inch
end play and the wedge into solid uncut nylon). Discard the nut and wedge and replace with the new ones. Discard the nut and/or wedge if there is
any evidence of mutilation, damage and/or scoring.
20. Prior to reinstallation of the axle shaft, clean and remove any metallic debris in the hub bolt holes. Also inspect for cracked material around the
holes, depth of the threaded hole (minimum 25.4 mm or 1 inch) and oversized threaded holes, and replace hub if any of these conditions are
present. Install the axle shaft and new axle flange gasket, lock washers and new axle shaft retaining bolts. Tighten the lock bolts, 55-67 N m
(40-50 ft. lb.).
21. Adjust the brakes.
22. Remove the safety stands and lower the vehicle.
Ford Integral Carrier Type Axle
