F 250 4WD Pickup V8-5.4L SOHC VIN L (1999)
5. Remove the floor duct.
1
Remove the two screws (one each side).
2
Remove the floor duct.
6. Remove the panel/floor door vacuum control motor.
1
Disconnect the vacuum line connector.
2
Remove the screws.
3
Slide the rod out of the door and remove the panel/floor door vacuum control motor.
NOTE: Rotate the vacuum control motor to disconnect the vacuum control motor rod from the panel/floor door.
INSTALLATION
1. To install, reverse the removal procedure.
