ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

Air Spring Filling or Refolding|Page 7055 > < Air Spring Filling or Refolding|Page 7053
Page 1
background image

Air Spring: Service and Repair
Replacement

Special Tools

Removal

WARNING:  The electrical power to the air suspension system must be shut off prior to hoisting, jacking or towing an air suspension vehicle.
This can be accomplished by turning off the air suspension switch located in the RH kick panel area. Failure to do so may result in
unexpected inflation or deflation of the air springs which may result in shifting of the vehicle during these operations.

WARNING:  Before repairing or installing any air suspension component(s), turn off the air suspension switch or disconnect the battery
ground cable to prevent vehicle damage or personal injury.

WARNING:  Do not attempt to install or inflate any air spring that has become unfolded to prevent vehicle damage or personal injury.

WARNING:  Failure to observe the following procedures may result in a sudden failure of the suspension system.

WARNING:  Any air spring which is unfolded must be refolded prior to being installed in a vehicle.

WARNING:  The air spring refolding procedure should not be used for an air spring which has never supported the vehicle's weight while in
the correctly folded position.

WARNING:  Vehicles with an incorrectly folded air spring(s) found after the vehicle has been driven, must have a new air spring installed.

WARNING:  Do not attempt to inflate any air spring which has collapsed while deflated from the rebound hanging position to the jounce
stop.

WARNING:  When installing a new air spring, care must be taken to not apply a load to the suspension until the air springs have been
inflated using the air spring fill procedure.

WARNING:  After inflating an air spring in the hanging position, it must be inspected for proper shape.

WARNING:  Do not remove an air spring under any circumstances when there is pressure in the air spring. Do not remove any components
supporting an air spring without either exhausting the air or providing support for the air spring to prevent vehicle damage or personal
injury.

NOTE:  The vehicle must be positioned on a suitable lifting device prior to deflating the air suspension system.

NOTE:  New Generation STAR (NGS) Tester can be used to emulate Superstar II Tester.

Air Spring Filling or Refolding|Page 7055 > < Air Spring Filling or Refolding|Page 7053