F 250 4WD Pickup V8-5.4L SOHC VIN L (1999)
7. Use a (A) feeler gauge to check the clearance between the (B) clutch pack retaining ring and the (C) pressure plate.
-
If the clearance is not within specifications, install the correct size retaining ring and recheck the clearance.
8. Install the washer and the (B) No. 7 needle bearing on the (A) direct clutch hub and install the direct clutch hub.
-
Install the needle bearing with the black side up, toward the direct clutch hub.
NOTE: Inspect the output shaft bearing surfaces for scores. Inspect the output shaft splines for wear. Inspect all bushings.
9. CAUTION: Make sure the seals are lapped correctly. Internal damage may occur.
Install the two direct clutch seal rings.
10. Install the output shaft hub.
-
Position the output shaft hub.
-
Install the retaining ring.
