F 250 4WD Pickup V8-5.4L SOHC VIN L (1999)
4. NOTE: Use clean, dry shop air.
Apply air pressure to the valve on the leak check tool.
5. With air pressure applied to the valve, inspect for leaks at the converter hub, the seams and the studs. A soap bubble solution can be applied
around those areas to aid in the diagnosis. If any leaks are present, replace the converter.
6. Remove the air hose. Release the pressure, and then slowly release the press. Remove the converter. Remove the tool.
Stator to Impeller Interference Check
1. CAUTION: To perform this check, do not use the pump stator support which will be installed in the transmission. Damage to the pump
stator support, front pump seal or front pump stator seal may occur.
NOTE: Obtain a scrapped pump. Remove the stator support, This can be used as a permanent tool to perform this check.
Position the stator support with the splines up.
