F 250 4WD Pickup V8-6.9L DSL (1983)
Figure 7
1.
The E0TZ-2B257-A proportioning valve has a 1/2"-20 thread size for the front brake system inlet port, Port A in Figure 7. Cut the end of the front
brake tube to replace the existing tube nut with a 1/2"-20 tube nut (use existing 1/2"-20 tube nut from rear brake tube). Reflare the front brake tube
as shown in Truck Shop Manual, page 12-01-14 and connect the tube to Port A.
2.
The E0TZ-2B257-A proportioning valve has a 3/8"-24 thread size for the rear brake system inlet port, Port B in Figure 7. Install a 3/8"-24 tube nut
(procure locally) on the rear brake tube and flare the tube as shown in Truck Shop Manual, page 12-01-14. Connect tube to Port B.
3.
Complete the installation, and bleed the brake system per Shop Manual Section 12-01.
4.
The front and rear tires must be inflated to pressure levels specified on the Safety Compliance Certification Label located on the driver's door rear
pillar.
5.
If the rear brake shoe and linings have been previously replaced, the linings must be verified for correct level. The correct linings are in service
assembly E1TZ-2200-B with the primary (front) lining color code yellow/red and the secondary (rear) lining color code white/white.
PART NUMBER
PART NAME
CLASS
E0TZ-2B257-A
Proportioning Valve, 275 psi
B
E1TZ-2200-B
Shoe and Lining Kit
BG
3/8"-24
Tube Nut (procure locally)
OTHER APPLICABLE ARTICLES: None
WARRANTY STATUS: Reimbursable within the provisions of the Warranty and Policy Manual.
OPERATION: M
TIME:
"Actual Time" as defined in the Warranty and Policy Manual. DLR. CODING: Basic Part No. 2B257 Code: 42