F 250 4WD Pickup V8-6.9L DSL (1983)
FIGURE 28
-
Apply a light coating of ESA-M1C75B lubricant to the shift lever lower ball and to the lever ball seat in the shift housing (see Sections A and B of
Figure 28).
-
Apply a 1/8 bead of RTV gasket compound, part number ESB-M4G195A, to the center section and inboard of each bolt hole of the mounting
flange (see Section B of Figure 28) of the shift housing.
-
Apply ESG-M4G194A Thread Sealer to the threads of the six shift housing-to-transmission attaching
bolt and lockwasher assemblies and secure the shift housing to transmission case. Tighten all bolts to 25-35 lbs.ft. torque.
-
Position the shift lever assembly to the shift housing and install as shown in Section A of Figure 28. Torque the retaining cap to 8-15 lbs.ft. until
the gasket is clamped securely.
-
Connect the back-up light wire to the back-up light switch on shift housing.
-
Install weather pad, floor pan cover, and floor mat or carpet as outlined in Section 16-24 of 1983 Light Truck Shop Manual.
-
Check gear lubricant level in the transmission, add additional ESP-M2C83-C gear lubricant if necessary to fill plug opening.
PART NUMBER
PART NAME
CLASS
01A-7034
Vent
C
353096-S
Plug
S
C1AZ-19590-B
Lubricant
AG
D6AZ-19562-A
RTV Gasket
A
D8AZ-19554-A
Thread Sealer
AM
D8DZ-19C547-A
Lubricant
BG
OTHER APPLICABLE ARTICLES: None
WARRANTY STATUS: Reimbursable within the provisions of the Warranty and Policy Manual.