F 250 4WD Pickup V8-7.3L DSL Turbo VIN K (1994)
Parking Brake Control: Service and Repair
REMOVAL
1. Remove the cowl side panel.
2. Disconnect the parking brake indicator light switch connector at the parking brake control.
3. Remove the three nuts holding the parking brake control to the steering column support bracket. Pull the parking brake control away from the
steering column support bracket.
4. Relieve tension on the parking brake system by having an assistant pull directly rearward on the intermediate cable until all front parking brake
cable is unwound from the parking brake control. Be careful not to damage the coating on the parking brake cable strand.
Parking Brake Control Tension Release
5. Insert a 5/32-inch drill bit or equivalent into the hole provided in the parking brake control.
6. Disconnect the front parking brake cable and conduit the cable connector.
7. Disconnect the barrel end of the front parking brake cable and conduit from the parking brake control.
8. Disconnect the cable conduit from the parking brake control.
-
Inserting a 1/2-inch 12-point box end wrench over the conduit snap fitting to compress the retaining fingers.
-
Back out the snap fitting.
INSTALLATION
1. Route the cable end fitting over the cable shoe. Snap the conduit fitting into the parking brake control. Insert the barrel end into the hole in the
track.
