F 250 4WD Pickup V8-7.3L DSL Turbo VIN K (1994)
b. Connect block cavity (DET 4) to the ratcheting rod with the slot of DET 4 in line with the slot in the ratcheting tool barrel.
c. Install both sets of upper (DET 5) and lower (DET 2) cavities to the threaded rods of the ratcheting tool.
d. Install one fuel line into the lower block cavity (DET 2) closest to the ratcheting end of the tool so that the extension of the fuel line is slightly
greater than the barb length of the connector.
e. Close the upper block cavity (DET 2) and tighten the thumb screw securely.
f.
Route the fuel line through the slot in the tool and the slot in DET 4.
g. Place the replacement tubing in the forward lower block cavity (DET 2) and repeat the previous three steps.
h. Place the barbed connector between the ends of the lines to be sliced and ratchet the tool until the nylon line has covered all three barbs of the
connector on both ends.
i.
After completing the splice, unscrew the thumb screws and release the lines. Repeat the previous five steps on the opposite line end to
complete the splice.
Completed Fuel Line Splice
6. Completed fuel line splice is shown in the Completed Fuel Line Splice illustration.
7. Install any remaining clips which were removed for this service and check that the fuel lines are secure in the original clips.
8. START engine and check for leaks.
