F 250 4WD Pickup V8-7.3L DSL Turbo VIN K (1994)
3.
Slip Heat Shrink Tubing (WT-5627-A) over cut wire as shown in Figure 7.
4.
Join replacement wire to existing cut wire and twist the ends together as shown in Figure 7.
NOTE:
ENSURE HEAT SHRINK TUBING IS ON CUT WIRE BEFORE SPLICING WIRES TOGETHER.
5.
Using only 63/37 rosin core solder (do not use acid core), apply solder and heat to spliced wires. (If repair is to be made in the engine
compartment, 60/40 rosin core solder may be used.)
WARNING:
USE ONLY A HEAT GUN. DO NOT USE A HAIR DRYER OR ANY FLAME TO HEAT THE SHRINK TUBING.
