F 250 4WD Pickup V8-7.3L DSL Turbo VIN K (1994)
REPAIR PROCEDURE
1.
Any wiring on air bag system circuits may be repaired as follows:
a.
If the insulation on any of the wires is nicked or cut, exposing bare wire, wrap affected area(s) with vinyl electrical tape.
NOTE:
USE FLAME-RETARDANT VINYL ELECTRICAL TAPE FOR ANY REPAIRS IN THE ENGINE COMPARTMENT.
b.
If wire(s) are only nicked, wrap affected area(s) with vinyl electrical tape.
c.
If wire(s) are cut, proceed to Step 2.
2.
Cut a piece of suitable length, same gage replacement wire.
