F 250 4WD Pickup V8-7.3L DSL Turbo VIN K (1994)
Clutch: All Technical Service Bulletins
A/T - E4OD/C6 Low One-Way Clutch Service Tips
Article No.: 94-8-20
^
TRANSMISSION - E40D AND C-6 - INSTALLATION INSTRUCTIONS FOR "NEW UNITIZED PLASTIC CAGE" LOW ONE-WAY
CLUTCH - 1989-94 MODELS WITH E40D AND ALL MODEL YEARS WITH C-6
^
TRANSMISSION - E40D AND C-6 - NO FORWARD ENGAGEMENT - SERVICE TIPS FOR INSTALLING "NEW UNITIZED PLASTIC
CAGE" LOW ONE-WAY CLUTCH - 1989-94 MODELS WITH E40D AND ALL MODEL YEARS WITH C-6
LIGHT TRUCK:
1989-94 BRONCO, ECONOLINE, F SUPER DUTY, F-150-350 SERIES, F-53
ISSUE:
A no forward engagement concern may be caused by an incorrectly installed "New Unitized Plastic Cage" Low One-Way Clutch.
ACTION:
Use the following procedure any time the Low One-Way Clutch is replaced using the "New Unitized Plastic Cage" Assembly.
REMOVAL PROCEDURE
1.
Remove the upper retaining ring, brass bushing, one-way clutch assembly and lower retaining ring, Figure 1.
2.
Discard all removed parts.
INSTALLATION PROCEDURE
1.
Install "New Unitized Plastic Cage" Low One-Way Clutch Assembly (F3TZ-7A089-A) into the rear of the Reverse Clutch Hub assembly.
NOTE:
DO NOT USE BRASO BUSHING (7E193) OR UPPER AND/OR LOWER RETAINING RINGS WITH THE "NEW UNITIZED PLASTIC
CAGE" LOW ONE-WAY CLUTCH. THE TABS ON THE CAGE WILL HOLD THE CLUTCH IN PLACE.
