F 250 4WD Pickup V8-7.3L DSL Turbo VIN K (1994)
Shifter A/T: Service and Repair
Manual Shift Lever Grommet
With E4OD
REMOVAL
Shift Linkage Grommet Replacement
NOTE: Some lever assemblies incorporate an oil impregnated plastic grommet in the end of the lever arm.
1. Place the lower jaw of the tool between the manual lever and control rod. Position the stop pin against the end of the control rod and force the rod
out of the grommet.
2. Remove grommet from manual lever by cuffing off large shoulder with knife.
NOTE: The grommet must be removed from the manual lever and a new one installed each time the rod is disconnected.
INSTALLATION
1. Prior to installing a new grommet, adjust the stop pin to 1/2 inch and coat the outside of the grommet with lubricant. Then place the grommet on
the stop pin and force it into the manual lever hole. Turn the grommet several times to be sure it is properly seated.
2. Adjust stop pin to the height shown in the Shift Linkage Grommet Replacement image. The pin height is determined by the length of the rod end
which is to be installed into the grommet. If the pin height is not adjusted, the control rod may be pushed too far through the grommet, causing
damage to the grommet retaining lip.
3. With the pin height properly adjusted, position the control rod on the tool and force the rod into the grommet until the groove in the rod seats on
the inner retaining lip of the grommet. Be sure the rod protrudes through the grommet approximately 1/4 inch after installation.
With C6
REMOVAL