F 250 4WD Pickup V8-7.3L DSL Turbo VIN K (1994)
Shifter A/T: Service and Repair
Manual Shift Lever Seal
REMOVAL
1. Remove manual lever position sensor connector. Check condition of electrical connectors and terminals, then repair as needed.
2. Remove lever control rod from manual lever, then the two manual lever position sensor bolts.
3. Remove shift cable or linkage from lever. Remove cable and fitting from ball stud using a screwdriver.
4. Loosen oil pan attaching bolts and drain fluid from transmission, then remove attaching bolts and pan.
5. Remove filter and seal assembly. Ensure seal is removed from bore.
Manual Lever Roll Pin Removal
6. Remove manual lever roll pin using remover tool No. T78P-3504-N or equivalent.
7. Remove inner detent lever nut. Hold lever with crescent wrench to prevent strain on lever assembly.
Manual Lever Seal Removal
8. Remove inner detent lever and park actuating rod assembly from manual lever.
9. Remove manual lever.
