F 250 4WD Pickup V8-7.3L DSL Turbo VIN K (1994)
Solenoid Screen Removal
7. Remove solenoid screen by turning counterclockwise and pulling out, as shown in the Solenoid Screen Removal image.
8. Remove three reinforcing plate attaching bolts, then the plate.
9. Carefully lower separator plate and gasket so check balls, Electronic Pressure Control (EPC) ball and spring are retained.
Intermediate Band Servo Assembly Removal
10. Remove servo snap ring and retaining plate, piston, rod assembly, and servo spring.
INSTALLATION
1. Reverse procedure to install, noting the following:
