F 250 4WD Pickup V8-7.3L DSL Turbo VIN K (1994)
4.
Using spanner locknut wrench while rotating the hub back and forth, tighten the inner locknut to 68 Nm (50 ft-lb) to seat the bearing.
5.
Back off the locknut 90 degrees.
NOTE: Hole pattern of lockwasher is offset with keyway to provide half-position settings by flipping washer over to obtain closest hole.
6.
Install the lockwasher so the key is positioned in the spindle groove. Tighten the inner locknut, aligning the pin into the nearest lockwasher hole.
