F 250 4WD Super Duty V10-6.8L (2002)
Safety Belt Bolt Bit
SPECIAL TOOL(S)
REMOVAL
NOTE:
^
New safety belt buckles, height adjusters, center adjust tongues and belts and retractors can be installed separately. However, if a safety belt
assembly was in use during a collision, a new belt and retractor must be installed as well as the center adjust tongue and belt and buckle assembly,
or the center adjust tongue and the cable and buckle assembly. When installing new safety belts and buckles, height adjusters, safety cables and
buckles, center adjust tongues and belt and retractors, use only the parts specified in the Ford Master Parts Catalogs for the make and model of the
vehicle being repaired. Safety belt assemblies must not be interchanged between vehicle models.
^
Safety belt buckles are shown, safety belt and buckle is similar.
1. Remove the rear seat back.
2. Remove the safety belt buckles.
1
Using the special tool 501-010 (T77L-2100-A), remove the bolt.
2
Remove the safety belt buckles.
INSTALLATION
1. To install, reverse the removal procedure.
^
See the removal procedure or Specifications for torque specifications.
NOTE:
^
Make sure the safety belt webbing is not twisted prior to installation.
^
Make sure to tighten bolts to specification.
2. Check the restraint system for correct operation.
Crew Cab
Torx Bit Tool Set Used For T55 "Torx Plus" Bit
