F 250 4WD Super Duty V10-6.8L (2002)
2. Remove the safety belt buckle.
1
Use the Seat Belt Bolt Bit to remove the safety belt buckle bolt.
2
Disconnect the safety belt warning indicator switch connector.
3
Remove the safety belt buckle.
NOTE:
^
Driver side shown, passenger side similar.
^
Passenger side safety belt buckle is not equipped with a safety belt warning indicator switch.
INSTALLATION
1. To install, reverse the removal procedure.
NOTE: Make sure to tighten bolts to specification.
2. Check the restraint system for correct operation.
SuperCab
Safety Belt Bolt Bit
SPECIAL TOOL(S)
REMOVAL
NOTE:
^
New safety belt buckles, height adjusters, center adjust tongues and belts and retractors can be installed separately. However, if a safety belt
assembly was in use during a collision, a new belt and retractor must be installed as well as the center adjust tongue and belt and buckle assembly,
or the center adjust tongue and the cable and buckle assembly. When installing new safety belts and buckles, height adjusters, safety cables and
buckles, center adjust tongues and belt and retractors, use only the parts specified in the Ford Master Parts Catalogs for the make and model of the
vehicle being repaired. Safety belt assemblies must not be interchanged between vehicle models.
