F 250 4WD Super Duty V10-6.8L (2002)
NOTE: The inboard and outboard tower cap covers are not interchangeable. The outboard cover sits flat on the tower cap. The inboard cover
sticks out from the tower cap.
7. Install the seat backrest trim cover J-clips.
8. Install the seat backrest trim panel.
1
Position the seat backrest trim panel to the seat backrest and lift up, engaging the upper retaining clips.
2
Push the sides of the seat backrest trim panel together, align the retaining clips to the seat backrest frame wires and release the cover, engaging
the retaining clips into the seat backrest frame wire retainer.
3
Install the seat backrest trim panel pin-type retainers.
9. Position the side trim cover onto the seat.
^
Vehicles with power seat, feed the seat control switch wire harness through the seat opening as noted in removal.
